Skip to main content

Checking an IP address

The stillorigin naughty list is a list of IP addresses that have sent abusive traffic, such as vulnerability scans, password guessing or floods of requests. stillorigin sentries drop traffic from addresses on it, unless the host running them has turned the list off.

How addresses get on the list​

  • stillorigin's team adds addresses.
  • Automatically: an address is added when sentries at three or more separate stillorigin customers block it for excessive traffic within 24 hours. One customer can never list an address on its own, however many servers it has. Only single addresses are listed this way (for IPv6, the address's /64 network). Addresses of stillorigin's own servers, customers' origin servers, private and reserved addresses, and the published address ranges of identified traffic (search engines, AI crawlers and the other identified services) are never listed automatically. A cluster also never applies a listed address that is one of its own origins or sentries, so a listing cannot take those sites offline.

Automatic listings follow the same rules as any other: the first listing lasts 7 days, and an address listed again within 90 days stays on longer (30 days, then 90 days). After an address is delisted, only new blocks count towards listing it again.

Using the list on your sentries​

On Settings, Use the stillorigin naughty list decides whether your sentries use the list. When it's on, your sentries drop addresses on the naughty list as well as those on your own deny list. When it's off, your sentries' automatic blocks for excessive traffic still count towards listing an address. Your sentries pick up a change within a minute.

Checking an address​

Anyone can check an address. You don't need an account. If you're signed in to the portal, you can also check from Naughty Delisting.

In the portal​

Sign in and open Naughty Delisting. Enter the IP address and click Check. The result uses the same fields as below. This check is rate limited; if you see Too many checks, wait a few minutes and try again.

In a browser​

Open stillorigin.app/check. The page checks the address you're visiting from straight away. To check a different address, type it in and click Check.

Under every result, the page says: "To take an address off the naughty list, request delisting. You'll need to request the code from the server at that address." Request delisting links to the delisting page. If the address is listed, a Request delisting button is shown as well.

From a server​

On a server without a browser, run:

curl https://stillorigin.app/check

This checks the server's own public address and prints the result as plain text. To check another address, add it to the end:

curl https://stillorigin.app/check/192.0.2.10

If the address is listed, the text result also prints the command to request a delisting code: curl https://stillorigin.app/delist/token. See Delisting an IP address.

What the result shows​

If the address is listed, you see:

FieldMeaning
ListedWhen the current listing started (UTC)
ReasonA general category, such as Scanning for vulnerabilities or Password guessing (brute force)
ExpiresWhen the listing ends by itself (UTC), or No expiry date
Listed rangeShown when the address is covered by a listed range rather than listed on its own
RemovalShown when a delist request has been approved and the address comes off the list at a set time

The check never shows who reported an address or which sites or servers it affected.

If a check says the address is not listed but a site still blocks you, that site's host or firewall may be blocking the address separately. Contact the site or its host.

Limits​

To keep the service fast for everyone, the number of checks from one address, and from one network, is limited. If you see Too many checks, wait a few minutes and try again.

Next step​

If your address is listed and you've dealt with the cause, you can request delisting.